This course was created with the
course builder. Create your online course today.
Start now
Create your course
with
Autoplay
Autocomplete
Previous Lesson
Complete and Continue
Oak Framing Basics - How to Make a Roof Truss
Introduction
About the Course (1:49)
The Juicy Bit (2:00)
Tools
Marking Out (10:13)
Hand Tools
Power Tools
Lifting Equipment (1:53)
Frame Design
Frame and Joint Design (5:51)
Joint Design (5:24)
Joint making (4:47)
Alternative ways of cutting the joints (8:57)
Level and Plumb (1:46)
Peg Making (13:06)
Pegging (3:49)
Principle Rafters
Marking Out (12:29)
Cutting the Joints (9:58)
The First Fit (5:11)
Fine Tuning the Fit (8:20)
Drilling the Peg Holes (1:27)
Saw Carving the Joint (4:42)
Using the Offset Pricking Tool (2:32)
High Collar
Marking out using a plumb bob (15:17)
Cutting the Tenons (9:23)
Marking Out the Mortices (2:09)
Cutting the Mortices (3:11)
Marking and Drilling the Peg Holes (3:08)
The First Fit (6:44)
Fine Tuning the Joints (2:27)
Drilling the Peg Holes (2:12)
Tie Beam
Positioning The Beam (2:40)
Using a Plumb Bob to Mark Out The Joints (25:11)
Cutting the Joints (13:21)
Fitting the joints (2:58)
Queen Posts
Rough Cutting and Cleaning Up (3:00)
Laying Out and Marking Up (16:02)
Cutting the Joints (5:23)
Fitting the Joints and Drilling the Peg Holes (3:39)
Now That the Truss is Together
Carpenters Marks (2:33)
Tidying up the Sharp Edges (1:25)
Installation (1:08)
Laying Out and Marking Up
Lesson content locked
If you're already enrolled,
you'll need to login
.
Enroll in Course to Unlock